|
|
|
CC-THERM is available as a stand-alone
or as an add-on programme.
A heat exchanger in CHEMCAD is calculated thermally obtaining
important parameters. CC-THERM is the tool to design this
heat exchanger. As a result the heat transfer coefficient
and the heat transfer area are calculated. Based on the
heat exchanger construction data a comparison with the
CHEMCAD calculation is obtained. It is possible to optimise
the heat exchanger heat transfer area automatically by
forcing design parameters such as tube length, tube passes,
tube layout, shell diameter and baffle design and spacing.
The results can be combined with the CHEMCAD flowsheet
thus allowing an automatic calculation of the heat transfer
coefficient with each CHEMCAD simulation.
CC-THERM shell and tube heat exchanger applications include
vertical and horizontal condensation, evaporation and
column thermo siphons. Plate and double pipe heat exchangers
as well as air coolers are also available but without
phase change.
The Highlight
The user does not need to enter physical properties. As
result a comprehensive data table in Microsoft EXCEL®
with TEMA report sheet is available.
Typical Applications of CC-THERM
→ shell and tube, double pipe and plate heat exchangers
→ air cooler
→ calculation of the overall heat transfer coefficient
(k or U) and the area
Advantages of CC-THERM
→ vertical or horizontal condensation and
evaporation (in case of shell and tube heat exchanger)
→ choice of construction
→ optimisation according to minimised area
→ vibration analysis of pipes
→ transfer of k or U -value and area to CHEMCAD
→ heat curve compatible with other heat exchanger
programmes
→ TEMA sheet
|
| |
|
|
|
|
|
|
